*The trigger on the handle must be held in order for the machine to produce spray
- The clean water tank on the back of the machine should be full
- The clean water tank should be sitting flush with the machine
- Remove tank and firmly push it back into place
- Plug machine in with a full clean water tank
- Hold the spray trigger down for 10-15 seconds and test for spray
- If still no spray, unplug the machine and remove the water tank
- Inspect water tank for cracks and leaks
- If your tank is cracked or leaking, a replacement should be ordered
- With water tank still removed, check for cracks on cap and rubber gasket
- If your cap or gasket is damaged, it should be replaced
- Remove brush window by grabbing the silver pull tab on the window and pulling upward
- Check for clogs in the spray tips on the foot of the machine
- Probe the spray tips with a paperclip to clear away any clogs
- Before reattaching brush window, check for spray from the spray tips
- Plug machine in & push hard floor button to turn on, do not recline
- Water should shoot up from spray tips
- If water flows from spray tips, turn the machine off and unplug
- Reattach brush window by lining up the tabs on the front edges of the foot - push the window into place until it clicks
- Plug machine in and test for spray
- If spray came out of the spray tips but not the brush window, the brush window should be replaced
- If there was no spray from the spray tips, Contact Us